Open the pt activity. perform the tasks in the activity instructions and then answer the question. which interfaces in each router are active and operational?

Last Updated on November 2, 2020 by Open the PT Activity. Perform the tasks in the activity instructions and then answer the question. Which command has to be configured on the router to complete the SSH configuration? • service password-encryption • transport input ssh • enable secret class • ip domain-name cisco.com Answers Explanation & Hints: The missing command to complete the SSH configuration is transport input ssh in line vty 0 4 mode.The commands service password-encryption and enable secret class do configure secure features on the router, but are not required to configure SSH. The command ip domain-name cisco.com is not required because the command i p domain-name span.com has been used. For more question and answers: Click Here Modules 16 – 17: Building and Securing a Small Network Exam Answers Full 100%

Modules 16 – 17: Building and Securing a Small Network Exam – ITN ( Version 7.00) – Building and Securing a Small Network Exam Answers 1. A network engineer is troubleshooting connectivity issues among interconnected Cisco routers and switches. Which command should the engineer use to find the IP address information, host name, and IOS version of neighboring network devices? • show version • show ip route • show interfaces • show cdp neighbors detail Explanation: The show cdp neighbors detail command reveals much information about neighboring Cisco devices, including the IP address, the capabilities, host name, and IOS version. The show interfaces and show version commands display information about the local device. 2. What information about a Cisco router can be verified using the show version command? • the routing protocol version that is enabled • the value of the configuration register • the operational status of serial interfaces • the administrative distance used to reach networks Explanation: The value of the configuration register can be verified with the show version command. 3. Which command should be used on a Cisco router or switch to allow log messages to be displayed on remotely connected sessions using Telnet or SSH? • debug all • logging synchronous • show running-config​ • terminal monitor 4. Which command can an administrator issue on a Cisco router to send debug messages to the vty lines? • terminal monitor • logging console • logging buffered • logging...

Question 1 CorrectMark 2.00 out of 2.00Flag question Question text Here is a link to the Open the PT Activity. Perform the tasks in the activity instructions and then answer the question. A technician is trying to use the tablet to control the IoT device Digital Lamp. The technician tries to login to the registration server with username admin2 and password admin2. However, the access is not successful. What are two problems? (Choose two.)Select one or more:The registration service on the server is off.The technician is using the wrong credential to login.The home gateway is not connected to the Internet.The digital lamp is using the wrong credential to connect to the registration server.The device is registered to the home gateway, not the registration server. Feedback Refer to curriculum topic: 6.2.1 When an IoT devices registers on a registration server, it requires a correct credential, which is created on the server. By default, the IoT registration service on the server is off.The correct answers are: The registration service on the server is off., The digital lamp is using the wrong credential to connect to the registration server. Question 2 CorrectMark 2.00 out of 2.00Flag question Question text How will a Packet Tracer environment be affected if a heater is added to a container named Branch Office and turned on?Select one:The temperature inside Branch Office will increase along with all containers in Packet Tracer.The temperature inside Branch Office will increas...